A comparison between rad-hard float zone silicon diodes as gamma dosimeter in radiation processing
DOI:
https://doi.org/10.15392/bjrs.v7i2A.681Palabras clave:
Gamma dosimetry, Silicon diode, High-dose, Float Zone diode, Rad-hard Si diodeResumen
In this work, we report on the results obtained with rad-hard Standard Float Zone (STFZ) and Diffused Oxygenated Float Zone (DOFZ) silicon diodes in radiation processing dosimetry. The dosimetric probes were designed to operate in the direct current mode, as on-line radiation dosimeter. The irradiation of the samples was performed using a 60Co source with a dose rate of almost 2.4 kGy/h. The current response of each diode was measured as a function of the exposure time in steps from 5 kGy up to 50 kGy to achieve a total absorbed dose of 275 kGy. In this dose range it is observed a significant decrease in the photocurrent generated in both devices due to gamma radiation defects produced in their active volumes. To mitigate this effect, the samples were pre-irradiated with Co-60 gamma rays at 700 kGy. Despite of being less sensitive, these devices presented stable and reproducible current signals with a relative sensitivity decrease of about 19% within the whole range of dose studied. The dose-response curves of the pre-irradiated diodes showed quadratic behavior with correlation coefficient higher than 0.9999 for total absorbed dose up to 275 kGy. The comparison of the FZ and DOFZ responses evidenced that the latter was slightly superior to the first. However, it is important to note that all pre-irradiated diodes can be used as gamma dosimeters in radiation processing applications.
Descargas
Referencias
BARTHE, J. Electronic dosimeters based on solid state detectors. Nucl. Instr. and Meth. Section B, v. 184, p. 158-189, 2001.
ROSENFELD, A. B. Electronic dosimetry in radiation therapy. Radiation Measurements, v. 41, p. S134-S153, 2007.
CASATI, M.; BRUZZI, M.; BUCCIOLINI, M.; MENICHELLI, D.; SCARINGELLA, M.; PIEMONTE, C.; FRETWURST, E. Characterization of standard and oxygenated float zone Si diodes under radiotherapy beams. Nucl. Instr. and Meth. Section A, v. 552, pp. 158-162, 2005.
MENICHELLI, D.; BRUZZI, M.; BUCCIOLINI, M.; TALAMONTI, C.; CASATIA, M.; MARRAZZO, L.; TESI, M.; PIEMONTE, C.; POZZA, A.; ZORZI, N.; BRIANZI, M.; DE SIO, A. Design and development of a silicon-segmented detector for 2D dose measurements in radiotherapy. Nucl. Instr. and Meth. Section A, v. 583, p. 109-113, 2007.
CAMARGO, F.; GONÇALVES, J. A. C.; KHOURY, H. J.; NAPOLITANO, C. M.; HÄRKÖNEN, J.; BUENO, C. C. MCz diode response as a high-dose gamma radiation dosimeter. Radiation Measurements, v. 43, p. 1160-1162, 2008.
International Atomic Energy Agency. Gamma Irradiators for Radiation Processing. IAEA Brochure, Vienna: 2005.
RD50 Status Report 2006. Radiation hard semiconductor devices for very high luminosity colliders. CERN-LHCC-2007-005 and LHCC-RD-013.
HÄRKÖNEN, J.; TUOVINEN, E.; LUUKKA, P.; NORDLUND, H. K.; TUOMINEN, E. Magnetic Czochralski silicon as detector material. Nucl. Instr. and Meth. Section A, v. 579, p. 648-652, 2007.
FRETWURST, E.; LINDSTRÖM, G.; STAHL, J.; PINTILIE, I.; LI, Z.; KIERSTEAD, J.; VERBITSKAYA, E.; RÖDER, R. Bulk damage effects in standard and oxygen-enriched silicon detectors induced by 60Co-gamma radiation. Nucl. Instr. and Meth. Section A, v. 514, p. 1-8, 2003.
HÄRKÖNEN, J.; TUOMINEN, E.; TUOVINEN, E.; LASSILA-PERINI, K.; MEHTÄLÄ, P.; NUMMELA, S.; NYSTEN, J.; HEIKKILÄ, P.; OVCHINNIKOV, V.; PALOKANGAS, M.; YLI-KOSKI, M.; PALMU, L., KALLIJÄRVI, S.; ALANKO, T.; LAITINEN, P.; PIROJENKO, A.; RIIHIMÄKI, I.; TIOURINE, G.; VIRTANEN, A. The Effect of Oxygenation on the Radiation Hardness of Silicon Studied by Surface Photovoltage Method. IEEE Trans. Nuclear Science, v. 49, n. 6, p. 2910-2913, 2002.
CAMARGO, F. Development of Dosimeters with Rad-Hard Silicon Diodes for High Dose Dosimetry. PhD Thesis, USP, São Paulo, 2009.
Descargas
Publicado
Número
Sección
Categorías
Licencia
Derechos de autor 2021 Brazilian Journal of Radiation Sciences (BJRS)

Esta obra está bajo una licencia internacional Creative Commons Atribución 4.0.
Licencia: los artículos de BJRS tienen una licencia internacional Creative Commons Attribution 4.0, que permite el uso, el intercambio, la adaptación, la distribución y la reproducción en cualquier medio o formato, siempre que se otorgue el crédito correspondiente al autor o autores originales y a la fuente, proporcione un enlace a la licencia Creative Commons e indique si se realizaron cambios. Las imágenes u otros materiales de terceros en el artículo están incluidos en la licencia Creative Commons del artículo, a menos que se indique lo contrario en una línea de crédito al material. Si el material no está incluido en la licencia Creative Commons del artículo y su uso previsto no está permitido por la regulación legal o excede el uso permitido, el autor deberá obtener el permiso directamente del titular de los derechos de autor. Para ver una copia de esta licencia, visite http://creativecommons.org/licenses/by/4.0/